I had some issues with circles/rounded surfaces when i upgraded from creality print v5.1.1.9490 to creality print v5.1.4.10249. Regular pla, speed 200 mm/s, temp 230°c, layer height 0.2, outer line. Corners are a problem because the filament tends to drag with the corners, creating air pockets on the outside of the corners where material should be deposited. Yes, you need to select the corresponding material configuration in the slicing. I do quite a bit of design stuff with sharp corners and find supports leading into and at the corners seems to be the fix. Loading filament unloading filament replacing filament. I also read a tip from @tinkergnome that changing the jerk settings. Both are printed on same temps.
Same With Leading Edges Around Your Model.
Loading filament unloading filament replacing filament. In cura you can enable 'acceleration control', and in particular you could increase wall acceleration to 1500. Both are printed on same temps.
It Seems That Creality Print Is Trying To.
Please refer to the feeding steps. I would like to know which settings in prusa slicer could decrease rounding the outer wall corners? I do quite a bit of design stuff with sharp corners and find supports leading into and at the corners seems to be the fix.
Yes, You Need To Select The Corresponding Material Configuration In The Slicing.
I’ve got an k1 speedy for 1 month or so, and since then i’m strugling with this kind of layers shifting and rounded corners, i’m printing with the basic settings from creality slicer.
Images References
In Cura You Can Enable 'Acceleration Control', And In Particular You Could Increase Wall Acceleration To 1500.
I do quite a bit of design stuff with sharp corners and find supports leading into and at the corners seems to be the fix. My prints are coming out with this rounded corners, anyone knows how to fix it? Same with leading edges around your model.
I Also Read A Tip From @Tinkergnome That Changing The Jerk Settings.
All of a sudden my k1 decided to round off sharp corners. It seems that creality print is trying to. Regular pla, speed 200 mm/s, temp 230°c, layer height 0.2, outer line.
Loading Filament Unloading Filament Replacing Filament.
I had some issues with circles/rounded surfaces when i upgraded from creality print v5.1.1.9490 to creality print v5.1.4.10249. Top one is from prusa slicer, bottom one is. I’ve got an k1 speedy for 1 month or so, and since then i’m strugling with this kind of layers shifting and rounded corners, i’m printing with the basic settings from creality slicer.
Please Refer To The Feeding Steps.
Both are printed on same temps. These are supposed to be sharp 90° angles, but they are being printed with a slight rounding off. Yes, you need to select the corresponding material configuration in the slicing.
I Would Like To Know Which Settings In Prusa Slicer Could Decrease Rounding The Outer Wall Corners?
Corners are a problem because the filament tends to drag with the corners, creating air pockets on the outside of the corners where material should be deposited.
